Display
The display hours and minutes are divided by a colon.
When showing temperature, the leading zeros are blanked out.
When the timer is running, the colon will blink once every second.
The unit counts down from the set time.
Example:
The preset time is
2:00
h, followed by a reading of
1:59
,
1:58
, etc.
The display reading indicates the time remaining until heating starts.
Indicator lights
Indicate the variable shown in the display, when lit.
When blinking, the setting can be changed. The new setting is stored with the OK
– button.
The indicator lights are (starting from left):
1. Preset time
2. Heating time
3. Temperature setting/measurement
4. Sauna light
5. Fan
BUTTONS:
ON_OFF
Starts and stops functions.
When the unit is on, this button will turn off all functions currently running and the display will be
turned off.
When the unit is in standby mode (display dark), this button will activate the controller. The
display will read 00:00.
OK
Accepts changes made to settings.
In standby- and running mode:
Press and release: saves setting in memory.
In standby mode:
Press and hold for 3 seconds: starts the heater with previously stored settings.
Arrow up (+)
Increases setting.
Arrow down (-)
Decreases setting.
NOTE!
The
arrow
buttons are used to increase or decrease the number shown in the display with
each press.
If you hold the button down for at least
1 second
, the number shown in the display will increase
or decrease
rapidly
.
If you hold the button down for at least
6 seconds
, the number shown in the display will
increase or decrease
extremely rapidly
.
Preset time
The Preset time can be changed by pressing the Preset time button. The corresponding
indicator light will start blinking indicating that it is possible to change the value. The setting is
changed with the Arrow up and Arrow down buttons.
Accept the changes by pressing OK, whereupon the setting will be stored in the
operation
memory
. The indicator light will remain lit.
When the unit is on heating timer, the preset time button will be locked out.
The initial setting is always 00:00 and maximum setting 24:00 h.
The preset time can be changed while the preset timer is running:
Press the Preset time button
– the corresponding indicator light will start blinking and the setting
can be made using the arrow buttons.
The hour and minute divider will not blink while making the setting, because the timer is
stopped when making changes to settings.
If you do not accept the changes by pressing OK within 5 seconds of the last button entry, the
change will not be recorded and the timer will resume from its last value. The hour and minute
divider will begin blinking and the indicator light will come on.
Installation and User Manual
Digi 1
4
