23
Description (Fig. 1):
A
Controls
B
Display
C
Air inlet (rear side)
D
Housing
E
Air outlet /
Oscillation air-slot
F
ON/OFF – main power switch
I = ON
0 = OFF
G
Remote Control
Fig. 1
Features:
•
Adjustment heat settings or temperature
•
Remote control
•
Oscillation air slot
•
Timer Function 12 hour
•
Weekly program
•
Open window detection
Wall-mounting
•
The heater may only be operated when mounted horizontally on a wall. The appliance is not suitable for
ceiling mounting.
•
Before you mount the heater on the wall please make sure that the heater is switched off (main-switch (F)
of position “OFF” and the plug is not put in the power socket.
•
The unit may be fixed only on the wall when the heater is switched off and the plug is not in the
socket-outlet.
•
The heater must be installed at least 1,80m above the floor. The heater must not be mounted less than
100cm away from side walls. The minimum distance between ceiling and upper heater housing should be
minimum 40cm.
•
For mounting the heater see Fig. 2 – Fig. 3.
•
For installation of the heater, care must be taken not to damage concealed cables. Please be careful while
drilling the holes. Never drilling holes under, above, besides etc. from the wall-socket.
•
Therefore, no holes under or above wall sockets get going and mount the device not or directly near
a socket as well as directly near combustible objects or pieces of furniture etc.
•
Pay attention to the named instructions and to safety regulations.
•
The accessories to the wall assembly are enclosing. The supply wall fixing are for brick walls; for
other wall types please consult your local hardware store and ask an expert.
•
If you have found a suitable place for this device, mount now by means of provided screws and dowels the
heater on the wall.
•
The diameter of the holes should just tightly contain the plastic wall plug. When the wall plugs are securely
in the wall, screw the provided screws into the wall plugs.
•
Please note to the fact that an accordance distance must exist between dowels and screws to be able to
mount the heater in even position on the wall. Hang up now the heater.
Slide the device to the left and
then down. Double check the heater is firmly hanged on the wall. If necessary turn the screws more.
•
Please pay attention, that the heater is mounted in even and firmly horizontal position. Do not use the
heater if the device not fix mounted on the wall or in uneven position.
Attention: The minimum distance between lower heater housing up to the floor should be
minimum 180cm. The minimum distance between ceiling and upper heater housing
should be min. 40cm and the distance to the side walls 1m.
24
Fig. 2
Fig. 3
4
How to use:
After switching on the appliance for the first time and also after prolonged operation without heating,
the appliance may smell for a short time. This will disappear when the heater has been on a short while.
Operating:
NOTE: the remote control buttons perform the same functions as those on the control panel on the unit.
WARNING: Never touch the device or the air-slot if the heater is in operation. Risk of injury!
•
After install the heater on the wall, ensure the main power switch (F) is on position “OFF”. Put now the
