Hella Gutmann MT 56, Operating Instructions Manual

Page: 31 / 292

EN
MT 56 Device Description
Intended Use
2. Take the MT 56 out of the packaging.
CAUTION
Danger of short circuit due to loose parts in or at the MT 56
Danger of destruction of the MT 56 and/or the automotive electronics
Never put the MT 56 into operation if you suspect that there are loose parts in or at the
module. Please contact the Hella Gutmann repair service or a Hella Gutmann trading partner
immediately in this case.
3. Check the MT 56 for mechanical damage and shake it slightly to ensure that there are no loose parts inside.
3.2 Intended Use
The MT 56 is a measurement module with a 2-channel oscilloscope. Channel 1 (ports CH1 and ST3) is intended for
measuring resistance and current. Channel 2 (port CH2) is intended for measuring voltage only.
Voltage at the measuring ports CH1 and CH2 of the MT 56 must not exceed 60 V/DC and 42 V peak. If it should be
nevertheless higher than 60 V/DC und 42 V peak, overvoltage can occur which leads to destruction of the MT 56 and or
the device. The voltage values to be measured must be shielded extra or even twice from dangerous line voltage.
There is a risk of electric shock.
The MT 56 can be operated in connection with the mega macs 56 of Hella Gutmann. In addition, the MT 56 can be
operated with the MT HV in connection with the mega macs X of Hella Gutmann. Diagnostic devices from other
manufacturers will not be supported. The MT 56 is
not suitable for the following repair work/voltage measurements:
• Electric appliances and devices
• Home electrics
• Power supply systems/line voltage
If the MT 56 is used in a way not authorized by Hella Gutmann, the protection of the MT 56, the mega macs 56 and the
mega macs X in combination with the MT-HV may be influenced.
31