1
3
unPACKIng / AssembLy
PAGE 6
IMPORTANT:
Do not remove the Helix from the box bottom until
further instructed later in this assembly manual.
Step 1:
Put the product on the floor and remove the top box cover to reveal the Helix as show above. Where the
box corners are printed “OPEN”, cut or tear the box and separate these corners. Lay the sides flat to the
floor.
Step 2:
Remove all parts from the box leaving just the main body of the machine on the bottom of
the box. Remove all parts from their plastic bags and organize the floor beside the Helix.
STABILIZERS INSTALLATION :
Step 3:
Attach the End Caps (with HELIX branding ) to the left and right stabilizers. The branded end caps install
on the end farthest from the attaching bolt holes. Attach Rear End caps (no branding) to the left and
right stabilizers at the end closes to the attaching bolt holes. They are front and rear specific but not left
and right specific.
Install the stabilizer adjustment feet (4) into the bottom of the stabilizers and adjust as required
Figure #2.
2
HLT2500.indd 6
04/10/2015 19:09