3
AssembLy - WHeeLs / WATeR bOTTLe
PAGE 12
1
2
3
4
Step 11:
Find the two bolt holes in the Center Upright Post. Locate the ‘Step 14’ hardware bag that contains the
water bottle bolts (Figure #1)
(Figure #2) Hold the water bottle holder up to the post as shown and install a bolt in the lower hole in
the water bottle holder bracket (Figure #3) and through to the lower bolt hole on the upright.
Do not tighten at this time.
Tilt the water bottle holder upright to align the top hole in the bracket with the top hole on the center
upright post. Install a 2nd bolt into that hole and then tighten with the allen key as shown in Figure
#4.
Step 13: NOTE: This part may be factory pre-installed
Raise up one side of the Helix onto a box or one of the styrofoam blocks from the packaging. Install
the transport wheel as shown. Make note in (Figure #1) above the location of the longer bolt and the
shorter bolt.
1
2
WATER BOTTLE HOLDER INSTALLATION
HLT2500.indd 12
04/10/2015 19:09