47
Use of gas burners
Ignition of the burners
The position symbol above each control knob indicates the burner that the knob controls.
Manual Ignition of the Gas Burners
If your appliance is not equipped with an ignition aid, or in case there is a failure in the
electric network, follow the procedures listed below.
For Hob Burners
: Push in the knob of the burner you wish to ignite and keep it pressed
while turning it anti-clockwise until the knob is in the
‘maximum’ position. Continue
pressing the knob and hold a lit match, taper or other manual aid to the upper
circumference of the burner. Move the ignition source away from the burner as soon as
you see a stable flame.
For Oven Burner
: Push in and turn the oven control knob anti-clockwise until the knob is in
the ‘maximum’ position. Hold a lit match, taper or oth
er manual aid to to the ignition hole
that is located on the front left corner of the burner. Move the ignition source away as
soon as you see a stable flame.
Electrical ignition by spark button
(button no. 6)
Push in the knob of the burner (button no. 8
–
product description) you wish to ignite and
keep it pressed while turning it anti-clockwise until the knob is in the 'maximum' position.
While keeping the knob pressed in, push the ignition button. Make sure that you press the
ignition button (button no 6
–
button description) immediately as a delay could cause a
build up of gas which may result in the flame spreading. Continue pressing the ignition
button until you see a stable flame on the burner.
Flame safety device
Hob burners
Hobs equipped with a flame failure device provide security in case of an accidentally
extinguished flame. If such a case occurs, the device will block the burners gas
lines and will avoid any accumulation of unburned gas. Wait 90 seconds before re- igniting
an extinguished gas burner.
Oven / Grill (If available) Burners
Regardless of the model of your appliance, all oven burners are equipped with a gas safety
device. For this reason, during ignition, keep the oven knob pressed until you see stable
flames. If the flames are cut out after you release the knob, repeat the ignition procedure.
If the oven burner does not ignite after you keep the burner knob pressed for 30 seconds,
open the oven door and do not attempt re-ignition for at least 90 seconds. If the oven
flames go out accidentally, repeat the same procedure.
VI.
USING THE PRODUCT
