www.heinner.com 2000W, 50Hz, 220-240V
3
1
Air outlet
2
Handle
3
Power selecting switch
4
Thermostat
5
Foot
1
Air outlet
V.
ASSEMBLY
1. C
arefully turn the radiator on it’s side to fit the feet
2. Position each feet as shown below and secure using the self tapping screws provided.
3. Two screws are required for each feet and this unit must not be used without the feel firmly
attached.
WALL MOUNTING
The heater is supplied with 4 sets of fixing brackets, screws and plastic wall plugs to enable it to be
mounted onto a wall if required.
If the heater is intended to mount onto the wall, the feet should not be fitted. The position must be
chosen carefully. It must not be in front of or below a power socket and must not be below a shelf,
curtains or any other obstruction. Also refer to the safety instructions.
Having decided on the location of the heater it is necessary to drill 2 fixing holes with the distance of
415mm on a horizontal line at a minimum height of 400mm from the floor, at a minimum distance of
600mm from ceiling and 300mm from side wall (see bellow). Allowance must be made for any floor
coverings, carpet etc and if any skirting boards are present, the fixing holes must be a minimum of
400mm above the top edge of the skirting board. Using the plastic plugs and fixing screws provided,
attach 2 of the fixing brackets to the wall. The other pair of fixing brackets must be attached to the
base of the heater using the feet retaining screws so that the brackets project out at the rear of the
heater and space the bottom edge away from the wall.
If required, these brackets may also be secured to the wall using the remaining fixing screws and
plastic wall plugs.
IV.
PRODUCT DESCRIPTION
