4. Usage
12
.
Floor
Curing
After initial Installation or Long Time Non-operation, a floor heating system may be very wet in
the concrete. Most of the heating capacity from heat pump unit is consumed to dry up the water in
the concrete for its evaporation. This floor curing function is used to dry the floor to ensure the
safety of heat pump system.
12.1) Floor Curing
Turn
ON
/
OFF
this
function
.
For
a
newly
-
built
floor heating system, floor must be cured before
setting the heat pump into standard working mode.
12.2) Floor Curing Temperature Setting Stage 1
12.3) Floor Curing Operation Duration Stage 1
Set
temperature
and
lasting
time
for
first
-
stage
of
Floor
Curing
operation.
12.4) Floor Curing Temperature Setting Stage 2
12.5) Floor Curing Operation Duration Stage 2
Set
temperature
and
lasting
time
for
second
-
stage
of
Floor
Curing
operation
.
12.6) Floor Curing Running Hours
12.7) Highest Water Temp. in Floor Curing Operation
Three
two
values
are
operation
data
during
floor
curing
operation
.
Unit
will
take
down
the
operation
time
and
highest
water
temperature
the
system
has
reached
during
Floor
Curing
operation
.
Note: After Floor Curing
operation
is
finished, if
water
temperature inside the distribution
system is still far below the set value of [
], it
means
there
has
still
some
water
inside
the
concrete of floor heating system, thus Floor Curing function should be turned ON again, until
temperature can increase over [12.4]
.
12.4
97
