HEIDENHAIN QUADRA-CHEK 100, Operating Instructions Manual, Page: 66 / 81

Chapter 4 Setup
4-24
are compared to the nominal values to generate correction coef-
ficients. Correction coefficients are generated for each segment
that deviates from the nominal value. The correction coefficients
are then used to provide linear compensation for only the seg-
ments requiring it.
Mount the standard on the stage and zero axes on the datum of
the standard. Measure and graph the nominal and actual seg-
ment values as shown below. A segment is any group of points A segment is any group of points
A segment is any group of points A segment is any group of points A segment is any group of points
that combine to form a straight line. that combine to form a straight line. that combine to form a straight line. that combine to form a straight line. that combine to form a straight line.
NOTE NOTE NOTE NOTE NOTE
The numbers used in this example are only meant to illustrate
The numbers used in this example are only meant to illustrate
The numbers used in this example are only meant to illustrate The numbers used in this example are only meant to illustrate
The numbers used in this example are only meant to illustrate
the process and are not intended to suggest actual values.
the process and are not intended to suggest actual values. the process and are not intended to suggest actual values. the process and are not intended to suggest actual values. the process and are not intended to suggest actual values.
Select the desired axis and en-
ter the nominal and actual end end end end end
points of each segment points of each segment
points of each segment points of each segment
points of each segment into
the SLEC Standard
Standard
Standard Standard Standard and Ob-
Ob-
Ob- Ob- Ob-
served served served served served data fields as shown be-
low. A maximum of 7 segments
(0-6) can be entered.
Enter the offset from the Ma-
chine zero to the standard’s da-
tum for the current axis into the
MZ Offset data field
MZ Offset data field
MZ Offset data field MZ Offset data field
MZ Offset data field.
Press the ON softkey
ON softkey
ON softkey ON softkey ON softkey to use SLEC compensation for the selected
axis.
When all the data are entered for all axes, press the left cursor left cursor left cursor left cursor left cursor
arrow arrow
arrow arrow arrow or Finish button
Finish button
Finish button Finish button Finish button to return to the Setup menu
Setup menu
Setup menu Setup menu Setup menu.