HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING, User Manual

Page: 34 / 618

34
14.1 Switch-On, Switch-Off ..... 438
Switch-on ..... 438
Switch-off ..... 441
14.2 Moving the Machine Axes ..... 442
Note ..... 442
Moving the axis using the machine axis direction buttons ..... 442
Incremental jog positioning ..... 443
Traversing with electronic handwheels ..... 444
14.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 454
Function ..... 454
Entering values ..... 454
Changing the spindle speed and feed rate ..... 455
14.4 Functional Safety FS (Option) ..... 456
General Information ..... 456
Explanation of terms ..... 457
Check axis positions ..... 458
Overview of permitted feed rates and speeds ..... 459
Activating feed-rate limitation ..... 460
Additional Status displays ..... 460
14.5 Datum Setting without a 3-D Touch Probe ..... 461
Note ..... 461
Preparation ..... 461
Workpiece presetting with axis keys ..... 462
Datum management with the preset table ..... 463
14.6 Using the 3-D Touch Probe ..... 470
Overview ..... 470
Selecting probe cycles ..... 470
Recording measured values from the touch-probe cycles ..... 471
Writing the measured values from touch probe cycles in datum tables ..... 472
Writing the measured values from touch probe cycles in the preset table ..... 473
Storing measured values in the pallet preset table ..... 474
14.7 Calibrating a 3-D Touch Probe ..... 475
Introduction ..... 475
Calibrating the effective length ..... 475
Calibrating the effective radius and compensating center misalignment ..... 476
Displaying calibration values ..... 477
Managing more than one block of calibrating data ..... 477
14.8 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 478
Introduction ..... 478
Basic rotation using 2 points: ..... 480
Determining basic rotation using 2 holes/studs: ..... 482
Workpiece alignment using 2 points ..... 483
14 Manual Operation and Setup ..... 437