25 / 44
PL
SK
CS
EN
Doporučený olej / Odporúčaný olej /
Recommended oil / Zalecany olej / Empfohlenes Öl
CASTROL MAGNATEC 5W-40 C3
of the fuel tank or add petrol while the engine is running or when the engine is hot. If petrol is
spilled, do not attempt to start the engine but move the machine away from the area of spillage
and avoid creating any source of ignition until petrol vapors have dissipated. Replace all fuel
tanks and container caps securely. Before tipping the machine (to maintain or drain oil) remove
fuel from tank.
WARNING: never fill fuel tank indoors, never with engine running or until the
engine has been allowed to cool for at least 15 minutes after running. Do not use
fuel which is older then 14 days. Old fuel in the fuel tank is the leading cause of
carburetor damage.
ADDING.FUEL
1. Remove the fuel tank cap (fig. 9A).
2. Fill the fuel tank to no more than 1 cm below bottom of filler neck.
3. Do not overfill. Wipe up spilled fuel before starting the engine.
4. Close the fuel tank cap.
ENGINE OIL
NOTE: This engine is delivered without oil, be sure to
put oil in the engine before the starting. Use only below
recommended types of oil.
RECOMMENDED.OIL
Use 4-stroke motor oil that meets or exceeds the requirements for API service classification API
SF, SG, SH or equivalent. Always check the API service label on the oil container to be sure it
includes the letters API SF, SG, SH, or equivalent.
Do not use SAE 10W-40 or 15W-40.
SAE 10W-30
is recommended for general use
in the summer
(for temperatures above 0°C)
-
recommended oil CASTROL GARDEN 4T.
SAE 5W-40
is recommended for general use
in winter
(for temperatures below 0°C)
-
recommended oil CASTROL MAGNATEC 5W-40.
Choose optimal oil viscosity that match the ambient temperature at which you are
going to operate the machine. DO NOT MIX OILS!
OIL.LEVEL.CHECK
CAUTION: Only check oil level with cold engine.
1. Place engine level. Check the oil level with the engine stopped and cooled down.
2. Remove the oil filler cap/dipstick (fig. 9B) and wipe it clean.
3. Insert the oil filler cap/dipstick into the oil filler neck until it stops, but do not screw it in. Then
remove it. Now read off the oil level on the dipstick.
4. If the oil level is near or below the lower limit mark on the dipstick, remove the oil filler cap/
dipstick, and fill with the recommended oil into the engine between the upper and lower
mark. Do not overfill.
5. Reinstall the oil filler cap/dipstick.
