28 / 44
PL
SK
CS
EN
OPERATION
1. Adjust snow throwing chute (direction and distance)
2. Start the engine (let it warm up to operating temperature and adjust the machine to the
outside temperature). Engage the first gear at released coupling lever – never change gear
while running machine - even with the engine turned off.
3. Press control lever of auger drive and the auger starts to work.
4. Press control lever of wheel drive and the machine start to move. For changing gear is
necessary to release the coupling lever.
STARTING THE ENGINE
MANUAL START
ELECTRIC START
Before starting release both coupling levers (fig. 10A, B). Before starting check fuel and oil level.
Insert the ignition key (fig. 15A) into slot. Make sure it snaps into place. Do not attempt to
turn the key. Without completely plugged key blower will not start.
Throttle lever (fig. 15D) put in position of symbol „Rabbit“.
For extreme cold operating conditions (under -10°C) press 1x to 3x primer (fig. 15E). Making
sure to cover vent hole when pushing. If the engine is warm, push the primer only once.
Cool weather may require priming to be repeated.
For cold start push the choke lever (fig. 15C) to 1 position (ON).
Turn the fuel valve (fig. 15B) to “ON“ position.
Pull the starting rope till you feel resistance
(fig. 15F). Then pull strongly and evenly.
Starting rope hold firmly and let slowly
rewind.
Plug in the power cord (fig. 14A). Press the power
supply (fig. 14B). Note: Do not push the button
for the power supply until you are sure the power
cord is properly connected into a power source.
After starting the engine remove the plug and
close the cover.
If the machine does not start in 5 seconds,
check again the whole machine. Starting up
again twice with a minute pause, otherwise
damage to the starter device.
Choke adjustment: When the engine starts to run, get choke lever slowly back to position 0/
RUN. Before each movement of the lever wait till the engine speed gets stable.
After starting let the engine run 1 – 3 minutes at low speed, in the meantime check the
engine condition, if it is running steadily or if you cannot hear unusual noise. Then adjust the
speed by throttle lever to required level.
STOPPING THE ENGINE
ELECTRIC AND MANUAL START
Having finished the work let the engine run for few minutes to let evaporate humidity and
melted snow and ice and the machine is dry for next use.
Throttle lever (fig. 15D) push to „Turtle“ symbol up to OFF.
