Heatilator • RAVE4013I • 2184-900 Rev. E • 8/09
56
A. Remove Fixed Glass Assembly
See Section 14.F.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox. The standard black rock media and manual bag
assembly are also shipped underneath the fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Install approved accessories per in-
structions included with accessories.
Contact your dealer
for a list of approved accessories
.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
14
14
Appliance Setup
E. Optional Glass Rock Media Kit
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Cleaning the Glass Rock Media
During shipment of the Rock Media, dust and debris can
accumulate in the rock bag. It is recommended that the
Rock Media be rinsed thoroughly with water to remove dust
and small glass rock particles. An easy method to clean
the Rock Media is to empty the contents of the bag into a
bucket and rinse thoroughly with a garden hose. Allow the
rocks to dry before installing them into the fi replace.
Installation
1. Position rock media placement jig over pilot shield to
prevent inadvertent rock placement in front of pilot
shield.
2. Figure 14.1 shows the outline of the media tray edges
and pilot transient ports. DO NOT install glass rock
media in the outlined area. This may cause delayed
ignition, undesirable burner fl ame, or lighting issues.
3.
Place an even layer of glass rock media around the
base pan as shown in Figure 14.2. Do not place glass
rock media between the inside edges of the media tray.
Place entire contents of the bag onto the media tray.
See Figure 14.2.
4. Remove rock placement jig by removing one screw
that attaches jig to pilot shield. See Figure 14.2. Place
smaller sized rock media on top of the pilot shield. See
Figure 14.3. Do not place rocks in front of pilot as-
sembly.
WARNING
Delayed Ignition Risk
• Place stones according to instructions.
• Do NOT place stones in area in front of pilot or
between burner tracks.
• Do NOT place stones in a position that they
may fall into area in front of pilot.
• Do NOT use any media other than the stones
supplied with this fi replace.
• Do NOT use more than one 10 lb. bag of rock
media per fi replace.
Fireplace will not function properly.
Delayed ignition may occur.
NO GLASS ROCK
MEDIA INSIDE
DASHED LINE.
Figure 14.1. Rock Media Placement Jig
Figure 14.2. Installing Glass Rock Media
ROCK MEDIA
PLACEMENT JIG
ROCK MEDIA PLACEMENT JIG
NO GLASS ROCK MEDIA BETWEEN DASHED LINES.
