12
Heatilator • HEIR36, HEIR42, HEIR50 Owner’s Manual • 2285-981 Rev. H • 5/15
Optional Heat-Zone
®
Gas Kit
An optional Heat-Zone
®
Kit is available for your appli-
ance. It must be installed by a quali
fi
ed service techni-
cian during the appliance installation process.
Appliance ON/OFF:
Your HEIR
fi
replace is supplied with a fully functional
remote control. This remote controls:
• ON/OFF Functions
• Flame height adjustments
• Cold Climate Feature
Please refer to the instructions included with the remote
control for more detailed operating instructions.
Figure 3.5 Control Module
Control Module Operation
1. The control module has an ON/OFF/REMOTE selector
switch that must be set. See Figure 3.5.
OFF Position: Appliance will ignore all power inputs and
will not respond to any commands from a wall switch or
remote. The unit should be in the OFF position during
installation, service, battery installation, fuel conversion,
and in the event that the control goes into LOCK-OUT
mode as a result of an error code.
ON Position: Appliance will ignite and run continuously
in the HI
fl
ame setting, with no adjustment in
fl
ame
output. This mode of operation is primarily used for
initial installation or power outage operation with battery
backup.
REMOTE Position: Appliance will initiate commands
from an optional wired wall switch and/or the wireless
remote (RC200).
2. If using a wired wall switch with the module in REMOTE
mode, the
fl
ame output can be adjusted with the HI/
LO selector switch on the module. See Figure 3.5.
Note that the
fl
ame HI/LO selector switch will become
inactive once an optional remote control (RC200) is
programmed to the control module. Note that the control
module will always ignite the
fi
replace on HI and remain
so for the initial 10 seconds of operation. If the HI/LO
is switched to the LO position, the
fl
ame output will
automatically drop to the lowest setting after the
fl
ame
has been established for 10 sec. After this 10 second
period, the
fl
ame can be adjusted from HI to LO with
the switch.
3. The control module has safety feature that automatically
shuts down the
fi
replace after 9 hours of continuous
operation without receiving a command from the RC200
remote.
4. If you intend to use both an optional wired wall switch
and the RC200 remote control to operate your
fi
replace,
the wall switch will override any commands given by
the remote.
5.
Module Reset
This module may lock-out under certain conditions.
When this occurs, the appliance will not ignite or
respond to commands. The module will go into
lock-out mode by emitting three audible beeps, then
continuously displaying a RED/GREEN error code at
its status indicator LED.
• Check battery tray. Remove batteries if installed.
Batteries should only be installed for use during power
outages. See Section G.
• Locate the module selector switch. (See Figure 3.5).
• Set the module selector switch to the OFF position.
• Wait
fi
ve (5) minutes to allow possible accumulated gas
to clear.
• Set the module selector switch to ON or REMOTE
position.
• Start the appliance.
WARNING! Risk of Explosion! DO NOT
press the mod-
ule reset switch more than one time within a
fi
ve minute
time period. Gas may accumulate in
fi
rebox. Call a quali-
fi
ed service technician.
Nine Hour Safety Shutdown Feature
The appliance has a safety feature that automatically
shuts down the
fi
replace after nine hours of continuous
operation without receiving a command from the wall
switch or optional remote.
I. Detailed Component Operating Instruc-
tions - IntelliFire
™
Plus
NG/LP GAS-TYPE
SELECTOR SWITCH
SELECTOR
SWITCH
FLAME HI/LOW
SWITCH
STATUS
INDICATOR LED
MODULE
