17
Heatilator • HEIR36-IFT, HEIR42-IFT, HEIR50-IFT Owner’s Manual • 2458-981 Rev. C • 2/17
Remote Control
Frequency:
Seasonally
By:
Homeowner
Tools needed:
Replacement batteries and remote con-
trol instructions.
• Locate remote control transmitter and receiver.
• Verify operation of remote. Refer to remote control
operation instructions for proper calibration and setup
procedure.
• Replace batteries as needed in remote transmitters.
• Place remote control out of reach of children.
If not using your
fi
replace for an extended period of time
(summer months, vacations/trips, etc), to prevent unin-
tended operation:
• Remove batteries from remote controls.
• Turn the ON/OFF/REMOTE switch on the control module
to OFF.
Venting
Frequency:
Seasonally
By:
Homeowner
Tools needed:
Protective gloves and safety glasses.
• Inspect venting and termination cap for blockage or
obstruction such plants, bird nests, leaves, snow, debris,
etc.
• Verify termination cap clearance to subsequent construc-
tion (building additions, decks, fences, or sheds).
• Inspect for corrosion or separation.
• Verify weather stripping, sealing and
fl
ashing remains
intact.
C. Maintenance Tasks - Quali
fi
ed Service
Technician
The
following tasks must be performed by a quali
fi
ed ser-
vice technician.
Glass Cleaning
(Exterior and Interior of Installed Glass)
Frequency:
Seasonally
By:
Quali
fi
ed Service Technician
Tools Needed
: Protective gloves, ceramic glass cleaner,
drop cloth and a stable work surface.
WARNING! Risk of Injury!
Glass installation and re-
moval must be performed only by a quali
fi
ed service tech-
nician.
CAUTION! Handle
fi
xed glass assembly with care.
Glass is breakable.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
•
DO NOT
clean glass while it is hot
NOTICE! Use only glass cleaner compatible with ce-
ramic glass.
Other types of glass cleaner may damage
the glass surface when exposed to high temperatures.
•
Prepare a work area large enough to accommodate
fi
xed
glass assembly and door frame by placing a drop cloth
on a
fl
at, stable surface.
Note
: Fixed glass assembly and gasketing may have res-
idue that can stain carpeting or
fl
oor surfaces.
•
Remove decorative front from
fi
replace and set aside
on work surface.
• See appliance installation manual for instructions to
remove
fi
xed glass assembly.
• Clean glass with a non-abrasive commercially available
ceramic glass cleaner.
- Light deposits: Use a soft cloth with soap and water.
- Heavy deposits: Use commercial fireplace glass
cleaner (consult with your dealer).
• See appliance installation manual for instructions to
replace the
fi
xed glass assembly.
• Reinstall decorative front.
Gasket Seal and Glass Assembly Inspection
Frequency:
Annually
By:
Quali
fi
ed Service Technician
Tools needed:
Protective gloves, drop cloth and a stable
work surface.
• Inspect gasket seal and its condition.
• Inspect
fi
xed glass assembly for scratches and nicks that
can lead to breakage when exposed to heat.
• Con
fi
rm there is no damage to glass or glass frame.
Replace as necessary.
