24
Heatilator • Caliber CNXT Series • 4047-132 Rev P • 11/07
E. Installing Vertical Termination Baf
fl
e
1.
Remove the glass (refer to Section 12.H.) to access the
fi
rebox and 5 in. inner
fl
ue.
2.
Fold the baf
fl
e (Figure 5.17) to an approximate 90° angle
(see Figure 5.18).
Note:
For vertically terminated installations only.
Figure 5.17 Flat Baf
fl
e
Figure 5.18 Baf
fl
e Bent to 90° Angle
Note:
If installing a vertical vent/termination run off the
top or rear of the appliance, the vertical termination baf
fl
e
supplied with the appliance may be used.
3.
Part of the refractory must be removed before installing
the vertical baf
fl
e.
• Remove the four screws holding the refractory retainers
in place. See Figure 5.19.
Figure 5.19 Remove Refractory Retainers
• Remove the retainers.
• Remove the right or left side refractory (only one side
must be removed) by gently raising the front of the
top refractory and lifting the side piece up slightly and
pulling out. See Figure 5.20.
Push & hold the
front edge up.
Figure 5.20 Remove One Side Refractory
• Remove top by gently lowering toward side just
removed and gently twisting out. See Figure 5.21.
Figure 5.21 Remove Top Refractory
Summary of Contents for CNXT4236IH CNXT4842IH
Page 88: ...88 Heatilator Caliber CNXT Series 4047 132 Rev P 11 07 This page intentionally left blank...
Page 89: ...Heatilator Caliber CNXT Series 4047 132 Rev P 11 07 89 This page intentionally left blank...
Page 90: ...90 Heatilator Caliber CNXT Series 4047 132 Rev P 11 07 This page intentionally left blank...
