Heatilator CNXT4236IH CNXT4842IH, Owner'S Manual

Page: 46 / 92

46 Heatilator • Caliber CNXT Series • 4047-132 Rev P • 11/07
Wiring the Wall Switch
Once a location is chosen and the electrical box is installed
proceed as follows. Install the provided control wire from the
fi replace to the switch location. (Control wire for Heatilator
products is supplied with the fi replace). Use caution not to
stress the wire around tight or sharp corners. Do not run the
control wire adjacent to existing or future phone, data, cable,
or electrical lines. The wire should not come into contact with
any part of the
fi replace exterior with the exception of where
it exits the outer wrap. Feed the wire to the electrical junction
box and through a provided or approved strain relief. Us-
ing a screw driver, connect the red wire to the “R” terminal,
the yellow or white wire to the “W” or “Y” terminal, and the
green wire to the “G” terminal. Do not over-tighten. Using
the screws provided, mount the switch to the electrical junc-
tion box right side up. Install provided cover plate using the
screws provided. Do not use a substitute cover even though
it may
fi t. The provided one is speci fi cally designed for the
automatic (thermostat) function of the unit.
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after
servicing.
CAUTION
ORANGE
GREEN
GROUND
BLACK
WHITE
BLACK
AUX
CONNECTION
BLACK
BLACK
GROUND PIGTAIL
GREEN
FLAME HIGH/LOW
AC
PLUG
ORANGE
ORANGE
RED
RED
FLAME ON
ADAPTER WIRES
FLAME
SOLENOID
IPI
VALVE
IPI
MODULE
BROWN
BLACK
FAN
CONNECTION
YELLOW
YELLOW
FRONT VIEW
REAR VIEW
RED
GREEN
YELLOW OR
WHITE
FAN THERMOSTAT
3V DC
BROWN
BROWN
RED
BLACK
BATTERIES
BLACK
RED
K
C
A
L
B
D
E
R
1
2
3
4
5
6
7
8
* May be labeled as “W” or “Y”.
*
de
R
)
E
L
A
M
E
F/
E
L
A
M(
de
R
)
E
L
A
M
E
F/
E
L
A
M(
*
TEMPERATURE
SENSOR SWITCH
Figure 10.2 Intelli fi re (IPI) Wiring Diagram