41
Heatilator • ECO-ADV-WS22 • 7057-128D • September 15, 2011
C. Blower Installation (Optional)
1. Align holes in mounting fl ange of blower with bolt holes in
appliance. Blower should be positioned at bottom of rear
outer skin as shown in
Figure 41.1
.
2. Insert and tighten bolts supplied with the kit, securing
blower onto outer wall of appliance.
3 Place the bracket containing the snap disc and magnet
under the bottom left rear corner as shown in
Figure 41.1
.
See pages 14 and 21
for detailed operating instructions
for the blower and snap disc.
Figure 41.1
The blower speed control for this unit is adjusted at the factory,
and normally does not require further adjustment.
D. Adjusting the Blower Speed Control
NOTE:
When the speed control is turned clockwise, it
will click on to high speed. Continue to turn the speed
control clockwise to decrease the speed. At full clock-
wise, the blower should blow gently, but should not
stop.
MANUAL: Over-rides the
Snap Disc
AUTO: Fan will turn ON/OFF
Automatically by the Snap Disc
Controls the Fan Speed
Snap Disc Bracket
with Magnet
Blower
Snap Disc
CAUTION! Risk of Shock!
• Do NOT remove grounding prong from plug
.
•
Plug directly into properly grounded 3 prong receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
