22
Heatilator • ECO-ADV-WS22 • 7057-128D • September 15, 2011
Figure 22.2
Baffle Boards & Blanket even with
front tube and resting on tubes
Baffle
Protection
Channel
Ceramic Blanket on Top
Tube Channels
2 pc
Baffle
Board
Burn
Rate Air
Control
C. Baffl e Removal
Figure 22.1 - Baffl e
1. Remove all ash from the fi rebox, and extinguish all hot
embers before disposal into a metal container.
2. Remove the baffl e protection channel by rotating it down
from the front tube.
Figure 22.2.
3. The
baffl e board has 2 pieces. With the ceramic blanket
still in place, slide one baffl e piece over the top of other
one and pull out top piece through the door opening and
then remove bottom baffl e piece.
Figure 22.1.
4. Remove the ceramic blanket.
5. Re-install the ceramic blanket and smooth out the blan-
ket.
6. Slide the baffl e pieces one piece at a time underneath the
blanket. Be sure the baffl e boards are even with the front
manifold tube and is resting on all tubes.
Figure 22.1 and
22.2.
7. Re-install the baffl e protection channel by rotating it up and
around the front tube so the bottom fl ange of the channel
rests behind the manifold tube. The baffl e boards and
blanket are tucked inside the rear of the baffl e protection
channel.
