HeathCo Secur360 SL-9600-90, Quick Start Manual

Page: 16 / 92

16
TRANS FRONT
8c Wire The Power Module
fig.7c
fig.7d
fig.7a
fig.7b
Connect the spade connector (fig. 7c) that is
connected to the wire you labeled “TRANS” to the
“TRANS” screw terminal on the chime and tighten
screw.
Connect the spade connector that is connected
to the wire you labeled “FRONT” (fig. 7d) to the
“FRONT” screw terminal on the chime and tighten
screw.
Insert either of the bare wires from the power module
into the empty opening of the quick connector with
the wire you labeled “TRANS” (fig. 7a) and lower the
orange arm fully.
Insert the remaining bare wire from the power
module into the empty opening of the quick
connector with the wire you labeled “FRONT”
(fig. 7b) and lower the orange arm fully.