HeathCo Secur360 SL-9600-90, Quick Start Manual

Page: 6 / 92

6
4 Remove Existing Doorbell Button
Remove your existing doorbell button by unscrewing
it from your exterior wall.
After unscrewing, you may have to firmly pull it from
the wall if mounted to a painted surface. Try rocking
it side to side to loosen if this is the case. Gently pull
away from wall to avoid breaking the wires.
If your button has no exposed screws, it is clipped
onto a baseplate that is screwed to the wall/trim.
Use a flathead screwdriver to release pushbutton
from baseplate.
Unscrew baseplate from the wall/trim.
Detach the two wires by unscrewing the screws
holding them down.
Gently disconnect the wires by unhooking them from
around the screw. You will RE-USE the old wires.
Discard old doorbell pushbutton.