Wireless Chime
© 2018 HeathCo LLC
209668-01A
1. Remove orange battery tab from push button.
Remove back of case by pushing in tab on bottom
with a small screwdriver (see Figure 1). Remove
orange battery tab.
2. Install 2 alkaline “AA” batteries. Press in latch on
rear of chime and lift off battery cover
(see Figure 2).
Install 2 alkaline “AA” batteries (not included) into
chime. Make sure batteries are installed according
to the diagram inside the chime
(see Figure 3).
Replace battery access door onto back of chime.
3. Test range. Temporarily position chime and push
button where you want them mounted. Press push
button to verify chime and push button work prop-
erly. If chime does not sound, see Troubleshooting.
Figure 1
Figure 2
Figure 3
WARNING: To prevent possible SERIOUS
INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
This chime requires 2 “AA” alkaline batteries (not included). In typical use,
alkaline batteries will last up to one year.
This package includes (Style of push button and chime may vary from illustration):
Model
Wireless
chime
Wireless push
button
Hardware
pack
7306
✔
✔
✔
TUNE
– HO
LD
1 S
ECON
D.
SYNC
– HO
LD
3 S
ECON
DS.
RESE
T – H
OLD
10 S
ECON
DS.
TUNE
– HO
LD
1 S
ECON
D.
SYNC
– HO
LD
3 S
ECON
DS.
RESE
T – H
OLD
10 S
ECON
DS.
