To see operational and troubleshooting information and videos,
3
go to www.hzsupport.com
208824-01
Note:
Light fixture and sensor should be mounted as shown
above when installed (depending upon type of installation).
Least Sensitive
Most Sensitive
Motion
Motion
Sensor
Wall Mount
Eave Mount
Wall Mount
Eave Mount
W
E
The motion sensor on this light fixture detects “motion”
by the movement of heat across the coverage area. The
motion sensor is more sensitive to the movement of heat
moving across the coverage area and less sensitive to the
movement of heat directly towards it.
INSTALLATION
Setting the Sensor for Wall or Eave Mounting
• For wall mounting, turn the ring around the sensor
clockwise until the “W” and the single indicator is
aligned with the mark on the front of the sensor (see
Figure 1).
• For eave mounting, turn the ring around the sensor
counterclockwise until the “E” and the double indicator
is aligned with the mark on the front of the sensor. (see
Figure 1).
Note:
There is a detent at each setting to indicate proper
alignment of the sensor.
Mounting the Solar Light Fixture
This fixture comes with a mounting plate. It is pre-
assembled on the light fixture for shipping.
Make sure there is enough vertical space above the mount-
ing plate to allow the light fixture to be mounted.
1. Press the bottom tab of the wall mounting plate and
slide the mounting plate from the light body (see
Figure 2).
2. Place the mounting plate against the mounting surface
and ensure the mounting plate is level. Mark the hole
locations (see Figure 3).
• If mounting to a wooden surface, drill two 3/32
in. holes into the mounting surface. Install the two
mounting screws through the mounting plate and
into the mounting surface.
• If mounting to wall board or brick, drill two 7/32
in. holes into the mounting surface. Insert the wall
anchors and attach the mounting plate using the
two mounting screws.
W
E
W
Figure 1
Figure 2
Figure 3
UP
OPEN
PRESS
TO CLO
SE
