Ball Size Adjustment Instructions
Adjustment #1 (Ball Pad)
Locate Allen Wrench (provided in package) and unscrew (4) four ball
height adjustment screws (2 on each side of machine).
Adjustment #2 (Ball Pad)
Warning: Do not put hand(s) inside machine at anytime.
Use chute adjustments handles (located on both sides of machine) to
move chute pad to desired ball size holes and tighten (4) ball height
adjustment screws (always make sure these screws are tight).
MACHINE IS SET TO PITCH BASEBALLS AT THE FACTORY.
Warning: Serious damage will occur if the wrong sized ball is put into
the Heater Combo Pitching Machine while set for a different ball size.
Adjustment #3 (Ball Chute)
Below the ball entry, locate & loosen wing nut until it is flush with the
end of the threaded bolt. Push the wing nut and bolt up toward the
metal floor of the Heater and rotate 90 degrees.
Adjustment#4 (Ball Chute)
On the end of the bolt there is a T-
head. When pushed up and rotated
90 degrees, the T-head slides out of
the ball chute and Heater housing.
Important:
Make sure machine is unplugged and tire is not spinning during the
following operations.
Periodically inspect the tire to make sure it is not worn out, flat,
or punctured. Serious damage could result if operated in any of
these conditions.
12” Softball Setting
11” Softball Setting
9” Baseball Setting
