Pre-Operating Instructions
Pre-Operation #1
Locate Allen Wrench (provided in package) and unscrew (3) three
wheel cover screws.
Pre-Operation #2
Locate a tire Pressure Gauge and check tire air pressure. Tire pressure
should be between 35 - 37 lbs. psi. If tire pressure reads low, use an air
pump to inflate the tire to 35 - 37 lbs. psi. If tire pressure reads high,
decrease the air pressure by pushing down the air stem bubble located
in the middle of the air stem. ••Inspect the air pressure periodically to
make sure air pressure is still within the 35 - 37 lbs. psi range.••
Check The Air Pressure In The Heater Combo Pitching Machine Tire.
Warning: Make sure Heater Combo Pitching Machine is unplugged
and the tire is not spinning during these operations.
Pre-Operation #3
Locate Allen Wrench (provided in package) and secure Wheel Cover back
on machine by tightening (3) three Wheel Cover Screws.
Warning - Serious Bodily Injury: Never operate Heater Combo Pitching
Machine until Wheel Cover is secured on the Heater Combo Pitching
Machine with the (3) three Wheel Cover Screws.
Check Heater Fuse Reset Button
Fuse Re-Set Button
The Heater Combo Pitching Machine has a fuse reset button which is
designed to protect the electronic circuit in the Heater Combo Pitching
Machine. If the Heater will not turn on, check this button to make sure
it is not popped out. If it is popped out, press it back in to reset the
fuse circuit breaker. This should allow the Heater Combo to operate
properly.
Important:
Periodically inspect the tire to make sure it is not worn out, flat,
or punctured. Serious damage could result if operated in any of
these conditions.
