Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. Q • 8/14
50
G. Positioning the Logs
Model: Cerona-36
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately,
refer to the following instructions.
Log Assembly: LOGS-Cerona36
CAUTION:
Carefully remove the logs from the packaging.
Logs are fragile!
STEP 1.
LOG #1 (SRV2106-701):
Place the notch on the left underside of log #1, over the log tab that is located on
the right side of the pilot bracket (
B
). Move the right end of log #1 forward until it hits the stick on the burner (
A
). The closer
the log is to the burner the more glow you will get. don’t place the log too close to the burner or sooting may occur.
STEP 2.
LOG #2 (SRV2106-703):
Fit log #2 on the
top branch of log #1
(A)
. Rest the formed groove of the lower
part of the log on the grate. It may be necessary to tilt Log
#1 forward to properly engage with Log #2.
1
1
2
3
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
2106-935B
6
1
2
5
3
4
STEP 3.
LOG #3 (SRV2106-705):
Place the “Y” portion
of the log in the grate tine and rest the log on the formed
portion of log #2.
B
A
A
FORMED
GROOVE