13
PREPARATION
MAX.
8.00"
OUTLET
VALVE
HOT WATER
TO 140
135
AUXILIARY
CONNECTION
PREVENTER
EXPANSION
BACKFLOW
AUXILIARY
CONNECTION
COLD WATER
INLET
COLD IN
BALL VALVE
DRAIN
VALVE MANUFACTURER
HOT OUT
AIR HANDLER*
FOR OTHER VALVES, CONSULT
GAS
TO 130
120
TANK
SPARCO AQUAMIX
MIXING VALVE SHOWN.
*
CHECKWITH AIR HANDLER
MANUFACTURER FOR PROPER
SIZING.
CIRCULATOR
( REQUIRED IN-LINE IF NOT ON
AIR HANDLER UNIT)
( SEE NOTE 4)
NOTES:
4. All circulators shall have an integral flow check.
3. Gas line must be rated to the maximum input capacity of the unit. Unit must have 10 feet of pipe after gas regulator.
1. Minimum pipe size should match connection size on Phoenix. If you require greater flow, upsize the pipe accordingly.
2. A Thermal Expansion tank suitable for potable water must be sized and installed within this piping system between the
check valve and the cold water inlet of the Phoenix.
LP-179-M
4/13/07
PHOENIX WITH AIR HANDLER ON SIDE
NOTE:
This drawing is meant to show system piping only. The installer is responsible for all
equipment and detailing required by local codes.
Summary of Contents for Phoenix
