3.
Lift the Storm Shell Back to the wall and position the S8 screw head (Step 2) into the top right
keyhole (Figure 10). Place a bubble level on top of the Storm Shell Back and rotate until the
Storm Shell Back is Level. Place a mark on the wall through the top left keyhole. Make sure to
mark the top left key hole at the center of the top (where the screw will rest). Remove the
Storm Shell Back from the wall and check to ensure that the mark for the top left keyhole is
centered on a stud. Repeat the procedure in Step 2 to drill and screw an S8 screw for the top
left keyhole. Mount the Storm Shell Back on the wall using the mounted screws and the top
left and right keyholes. Check that the Storm Shell Back is level using the bubble level.
Figure 10
4.
Place a mark through the Storm Shell Back onto the wall in the remaining six (6) mounting
locations (Figure 11). Remove the Storm Shell Back from the wall and ensure that the six (6)
remaining mounting location marks are located over a stud. For position B, use the same drill
procedure as Step 2 (1/8” drill bit 1.5 inches deep
–
30 mm). For position A, drill a hole using
a
1 4
⁄
” drill bit, 3 inches deep
(60 mm).
Figure 11
–
Storm Shell Back Mounting Locations
A
B
A
A
A
B
B
B
60mm
φ5.
5mm
30mm
φ4m
m
A
B
Top Right Keyhole
Top Left Keyhole
