15
Step 7. Installing Logs and Ember Material
Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned.
If the logs have been packaged separately, refer to the
installation instructions that accompany the logs.
Save
the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
Placing the Ember Material
Three separate bags of ember material are shipped with
this gas appliance. The bag labeled Golden Ember (GE-
93) is flame colorant material. The bags labeled Glowing
Ember (050-721) is standard glowing ember material.
To place the ember material:
•
Open the left and right door panels on surround.
•
Unlatch the latches at the right and left sides of the
glass door by pulling latch towards you and away from
fireplace (see Figure 9).
•
Remove the glass door from the unit.
Figure 9. Glass Assembly Latch
•
Place a dime size piece of glowing ember material near
port holes in burner top, sides and front (see Figure 10).
Figure 10. Placement of the Ember Material
•
Space ember pieces about a 1/2 inch apart.
•
Never press embers into burner ports.
•
Cover the top of the burner with a single layer of ember
material. Then sprinkle GE-93 (Golden Ember) on top of
the burner.
•
Save the remaining ember materials for use during fire-
place servicing. The embers provided are sufficient for 2
to 4 applications.
•
Replace the glass door.
•
Re-install and latch the glass door.
Combustible materials
MUST NEVER
overlap
onto the front face.
NOTE:
REMOVE GLASS DOOR ASSEMBLY
FROM THE INSERT BEFORE SURROUND
INSTALLATION.
1. Find the coiled low voltage wires and ON/OFF
switch attached to outer right side of the insert
(Figure 11).
2. Disconnect the ON/OFF switch from the low
voltage wire leads, and insert the ON/OFF
switch through the hole at the upper right corner
of the surround - it will be retained in the hole.
Step 8. Installing Trim Surrounds
Figure 11.
EMBER
MATERIAL
ON/OFF
SWITCH
SURROUND
FIREBOX
SURROUND
WITH TRIM
PULL TO
UNLATCH
GLASS LATCH