Heat & Glo • CERONA-36-IFT, CERONA-42-IFT Installation Manual • 2558-980 Rev. C • 3/21
50
F. IntelliFire™ Touch Control System Setup
• Detailed instructions for electrical wiring and connec
-
tions are provided in Section 8.
• Determine if this appliance is equipped with a Module
Reset Switch. See Section 8. Verify this switch is in
the ON position.
• Verify that the 3-Position switch on the IFT-ECM is
switched to the REMOTE position. Detailed Operating
Instructions for the IFT-ECM are provided in Section
3.K of the Owner’s Manual.
Figure 11.3 IFT-ECM
This appliance is factory-equipped with an IntelliFire™
Touch
remote control. The remote was paired to the ap
-
pliance tested at the factory. It does not need to be paired
again, unless an accessory kit will be added at the time
of installation. If no additional accessory will be added,
simply follow steps one through seven below.
1. If installed, remove batteries from remote.
2. Verify that the new appliance has power and secure
electrical connections.
3. Adjust the ECM selector switch to ‘REMOTE’ mode.
4. Switch the master reset switch to ‘ON’ (if equipped).
5. Wait to verify LED indicator on the ECM stops flash
-
ing.
6. Install batteries in the RC400 remote.
7. The RC400 remote will automatically pair to the appli
-
ance as pre-set at the factory.
3 POSITION SWITCH
TOP VIEW
LED INDICATOR
Figure 11.4 Glass Assembly
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
G. Fixed Glass Assembly Removal and Re-
placement
WARNING! Risk of Asphyxiation!
Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
•
DO NOT
strike, slam or scratch glass.
•
DO NOT
operate appliance with glass removed, cracked,
broken or scratched.
•
Replace as a complete assembly.
Removing Fixed Glass Assembly
Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 11.4).
Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
H. Install Decorative Barrier
Marble, brass, brick, tile, or other noncombustible materi
-
als can be used to cover up the gap between the sheet
rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles.
• Decorative barrier fronts
WARNING! Risk of Fire!
Install ONLY decorative barrier
fronts approved by Hearth & Home Technologies. Unap-
proved decorative barrier fronts could cause appliance
to overheat.
IMPORTANT! This appliance requires an installed
decorative barrier front to prevent direct contact with
the hot viewing glass. DO NOT operate the appliance
with the barrier removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative barrier front.
