39
Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. L • 4/15
9
9
Appliance Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE:
Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
A. Top Vent
Figure 9.3
Cut the metal retaining band and fold the sides out.
Figure 9.5
Remove and discard the seal cap, insulation
donut, insulation plug, and the insulation basket. Attach
the
fi
rst vent section (it will snap into place). Slide the vent
gasket onto the vent section and then, up against the ap-
pliance. Secure the vent gasket to the appliance with two
self-tapping screws found in the manual bag. Note: The
vent gasket can found in the manual bag.
Proceed to Section 9. C.
Figure 9.2
Fold heat shield back and secure with screw.
Remove the elbow heat shield by removing the screws
holding it to the top of the appliance. Refer to Section
8.B to determine if the elbow heat shield is required.
Remove screws to access vent.
NOTICE:
Once the vent cap has been removed it CANNOT
be reattached.
Figure 9.4
Fold the center parts of the retaining band up
and use to remove the vent cap.
Figure 9.1
Remove screws from top heat shield.
TOP HEAT SHIELD
TOP HEAT SHIELD
REMOVE SCREWS
REMOVE SCREWS
ELBOW HEAT SHIELD
ELBOW HEAT SHIELD
ELBOW HEAT SHIELD
ELBOW HEAT SHIELD
FOLD HEAT SHIELD BACK
FOLD HEAT SHIELD BACK
SECURE WITH SCREW
SECURE WITH SCREW