Heat & Glo • ST-36TR-IPI, PIER-36TR-IPI • 2176-900 Rev. L • 4/15
12
Initial Break-in Procedure
• The fireplace should be run three to four hours
continuously on high.
• Turn the
fi
replace off and allow it to completely cool.
• Remove
fi
xed glass assembly. See Section 14.G.
• Clean
fi
xed glass assembly. See Section 3.
• Replace the
fi
xed glass assembly and run continuously
on high an additional 12 hours.
This cures the materials used to manufacture the
fi
re-
place.
NOTICE! Open windows for air circulation during
fi
re-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
J. After Fireplace is Lit
K. Frequently Asked Questions
ISSUE
SOLUTIONS
Condensation on the glass
This is a result of gas combustion and temperature variations. As the
fi
replace warms, this
condensation will disappear.
Blue
fl
ames
This is a result of normal operation and the
fl
ames will begin to yellow as the
fi
replace is al-
lowed to burn for 20 to 40 minutes.
Odor from
fi
replace
When
fi
rst operated, this
fi
replace may release an odor for the
fi
rst several hours. This is
caused by the curing of materials from manufacturing. Odor may also be released from
fi
nishing materials and adhesives used near the
fi
replace. These circumstances may require
additional curing related to the installation environment.
Film on the glass
This is a normal result of the curing process of the paint and logs. Glass should be cleaned
within 3 to 4 hours of initial burning. A non-abrasive cleaner such as gas
fi
replace glass
cleaner may be necessary. See your dealer.
Metallic noise
Noise is caused by metal expanding and contracting as it heats up and cools down, similar to
the sound produced by a furnace or heating duct. This noise does not affect the operation or
longevity of the
fi
replace.