16
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. Q • 6/10
WARNING: ENSURE THAT THE HEATER GASKET
SUPPLIED WITH THE HEATER SEALS BETWEEN
THE FIRST FLUE COMPONENT AND THE OUTER
HEATER WRAP.
2. Assembling Flue Components
Insert the inner fl ue of section A into the fl ared inner
fl ue of section B.
Start the outer fl ue of section A over the outer fl ue of
section B (see Figure 1.19).
Note:
The end of the pipe
sections with the lances/tabs on it will face towards
the appliance.
Once both inner and outer fl ues are started, press
section A onto section B fi rmly until all lances have
snapped into place. Check to make sure they have
snapped together (see Figure 1.20) and the seams are
not aligned (see Figure 1.21). Tug slightly on section A
to confi rm it has completely locked into place.
Figure 1.19
Figure 1.20
Figure 1.21 Seams
Note:
Make sure that the seams are not aligned to
prevent unintentional disconnection.
CORRECT
INCORRECT
NOTE:
Make sure that seams are
NOT
aligned to
prevent unintentional disconnection.
For elbows that are changing the fl ue direction, two
screws minimum should be put in the outer fl ue at the
joint to prevent the elbow from rotating.
A
B
Fire Risk
Exhaust Fumes Risk
Impaired Performance of Appliance
• Overlap pipe slip sections at least 1-1/2
inches (38 mm).
• Use pilot holes for screws.
• Screws must not exceed one inch
long.
• Pipe may separate if not properly
joined.
WARNING
