Heat & Glo • 6000PLUS • 2063-900 Rev. E • 11/05
21
Possible Cause
4. Blue flames
a. Cold start
Symptom
This is normal operation and the flames will begin to yellow
as the burners and logs heat.
5. Odor from the appliance
a. New appliance
The appliance may release an odor for the first several
hours of operation from paint curing and manufacturing oils
burning off. This is normal and will dissipate with time.
6. Appliance does not turn on
a. No power to appliance
b. No power to
HRV200PLUS
c. No signal from the
appliance to the
HRV200PLUS; i.e.
12V CD not present
at “HI” terminal
d. Control wiring be-
tween appliance and
HRV200PLUS
incorrect
e. Appliance terminal
block wired incorrectly
f. Inadequate draft
causing limit switches
to shut appliance off
Check breaker and disconnects to the appliance.
Check breaker to HRV200PLUS and ensure ventilator is
plugged in with the door closed.
Check the dashboard “FLAME” switch. Check any acces-
sory switched connected REM terminals. Replace as
needed.
Check wiring for correct connections and continuity.
Check appliance wiring per wiring diagram.
Check HRV200PLUS filters - clean as needed.
Check HRV200PLUS exhaust termination - repair, clean or
replace as needed.
Check appliance exhaust venting and connections. Ensure
venting is not kinked or crushed. Ensure all connections are
properly installed and secured.
Check HRV200PLUS blower motor. Ensure motor is
operation on high speed.
Check HRV200PLUS blower wheels. Ensure blower wheels
are clean - service as necessary per HRV200PLUS manual.
Check HRV200PLUS heat exchanger core. Clean and
service as necessary per HRV200PLUS manual.
Corrective Action