25
Heat & Glo • 6000GBV, 6000GBV-IPI • 2104-900 Rev. G • 9/08
Appliance Setup
12
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result in
a safety hazard.
• Only Hearth & Home Technologies
approved accessories may be used safely.
WARNING
D. Lava Rock, Vermiculite, Rockwool/
Ember Placement
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Explosion Risk.
WARNING
Improperly placed embers interferes with proper burner
operation.
Placing the Ember Material
Figure 12.1 Placement of Embers
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included with
accessories. See Service Parts List for appropriate acces-
sories. Refer to
Section 16
.
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
®
onto the burner care
should be taken so that the ports are not covered. Place
the dime-size ember pieces just in front of the port trail,
but not on or in between the ports (see Figure 12.1).
Failure to follow this procedure will likely cause lighting
and sooting problems.
E M B ER M ATE RIAL
• Place Mystic Embers on areas of base refractory away
from port holes. Use this material to give the appliance
a realistic ash bed.
• Save the remaining ember materials for use during appli-
ance servicing. The embers provided should be enough
for 3 to 5 applications.
