Hearthstone Quality Home Heating Products, Inc
CARINA Series 8910
21
Installing or Replacing the Batteries
1.
The valve control module is powered by four “AA” batteries. The batteries are mounted within the Valve
Receiver Module located underneath the fireplace, behind the surround, attached to a slide-out
mounting bracket for easy accessibility.
2. Loosen the thumb screw on the module slide-out mounting bracket by turning counter-clockwise until
the threads are fully disengaged from the base bracket.
3. Rotate the Valve Receiver Module and mounting bracket. Toward you 90 degrees.
4. Slide off the Battery compartment cover.
5.
Install the 4 “AA” batteries, supplied, using the guides inside the battery pack to show you the correct
battery orientation.
6. Replace the battery compartment cover. Rotate the Valve Receiver Module and mounting bracket into
its home position and tighten the thumb screw to secure.
7.
The remote handset is powered by three “AAA” batteries. The access panel is located on the back of
the handset and simply snaps open to provide access to the battery compartment. Install the three
batteries as shown on the label inside the remote control battery compartment
8. Replace the remote handset access panel
Installing Convection Air Ducts:
With the front glass panel fitted, you now need to install the
two convection air ducts that were shipped in the accessory
box with the fireplace insert.
Align the top of the duct with the air channel on the top of
the insert.
Insert the “keyed” tabs into the slots provided on the insert
front frame, and seat in place.
Only trim kit(s) supplied by the manufacturer shall be used in
the installation of this appliance.
Draft relief openings must not be covered or blocked.
Both Convection air ducts need to be in position before
the Fireplace Surround with Integrated Screen can be
installed
