3
Hearth & Home Technologies • IFT-RC400 & IFT-ACM Installation Instructions • 2326-982 Rev. Q • 4/21
Figure 6 Install the Wall Mount
Figure 5 Install Batteries, Child Safety Switch, and Brand / Dealer
Programming
E. Wall Mount Installation (Optional)
1. Detach the IFT-RC400 from the wall mount.
2. Secure the wall mount on a flat wall surface using the
two #6 screws and wall anchors provided. See Figure
6.
3.
Place the IFT-RC400 inside the wall mount.
See Figure 9.
8. Connect the female end of the power cable that came
with the kit into the IFT-ACM. Ensure that power cable
is securely and fully inserted into the IFT-ACM. Plug
the three prong male plug into the junction box of the
appliance. Verify that the junction box has power.
See Figure 4.
9. Move the three-position switch on the IFT-ECM to the
REMOTE position. The green LED will blink three
times. A few seconds later, an audible “beep” will oc
-
cur to indicate that the system is ready.
10. Set the RC400 face down on flat surface when install
-
ing batteries. DO NOT touch the screen during bat
-
tery installation or removal.
11. Remove the battery cover from the back of the IFT-
RC400 and install the four AAA batteries in the proper
orientation marked in the battery cavity. Ensure the
child lock switch adjacent to the battery cavity is in the
UNLOCKED position. See Figure 5.
12. Program the IFT-RC400 for the correct brand of appli-
ance using the “Brand Programming” instructions in
Section F of this instruction.
13. Follow the pairing procedure, as described in the Sec
-
tion G of this instruction, to pair the IFT-RC400 to the
IFT-ECM.
BRAND/
BRAND/
