set mode
Parameter loop
Water
Powder
Hot water
temp.
Cold water
temp.
Cup counts
Press and hold the “Set” button for 3 seconds till the screen shows SET to set Parameters.
The “Mode” key is used to shift “WAT ”,”POW ”, “HEA ”, “COO” and “CUP ” cycle per press.
Adjust water
When the digital screen displays “
”, At the same time, press the hot
drink key on the glass panel which needs to be adjusted the channel, then
press “-” or “+” button to adjust the water.
Adjust powder
When the digital screen displays “
”, At the same time, press the hot
drink key on the glass panel which needs to be adjusted the channel, then
press “-” or “+” button to adjust the powder.
Adjust hot water temperature
When the digital screen displays “
”, then press “-” or “+” button to
adjust the hot water temp. The range allowed is 20℃~96℃.
When the digital screen displays “
”, then press “-” or “+” button to
adjust the hot water temp. The range allowed is 5℃~15℃.
Adjust cold water temperature
When the digital screen displays “
”, then press the flavor key on
the key pad respectively to check the cup counts dispensed per flavor.
Cup dispensed count
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
.
.
.
.
.
Adjust Concentration
After entering to “
” model ,(Fig.2), and then press the flavor key
you want to adjust to change the water ratio. The screen shows 9.0
,(Fig. 3), which is the default setting. Press “-” or “+” button to reset
the water ratio. There will be 0.5 ,(Fig. 5), changes on the value by
press one time. You can also press and hold the button to adjust the
value faster. The range allowed is 0-99.
Press and hold the “Set” button for 3 seconds till the screen
shows “
” , (Fig.1), to reset
s .
parameter
Follow the same steps to reset the other flavors to reset the
water of other flavors as needed.
After changing the water, press “mode” button again to enter to “
”
mode (Fig. 4) and then press the flavor key you want to adjust to change
the powder ratio. The screen shows 5.0 (Fig. 5) which is the default
setting.Press “-” or “+” button to reset the powder ratio. There will be
0.1 changes on the value by press one time. You can also press and hold
the button to adjust the value faster. The range allowed is 0-99.
For reference only, the value changes at " 1" means the amount of
powder discharged changes at approximately 2.2g while value changes
at "1" means approximately 13ml changes of water respectively.
Fig.7
Cups Count
Press and hold the “Set” button for 3 seconds till the screen
shows “
” , (Fig.1), to reset
s .
parameter
Press the “Mode” button for five times till the screen
displays “
” (Fig.7)
After entering the “
” mode, then press a certain flavor key
to show the count dispensed. You can delete the cup count record
thru press and hold the “-” button for seconds till a beep is heard.
Set Display
Setting & Query