Connect one end of the inlet pipe to the
pipeline joint and the other end screw the nut
onto to the dispenser .
Note: Water supply pressure range
0.05 Mpa~0.45 Mpa.
Pipeline
Water Supply
Topper Mounting
( 1 ) P r e p a r e a b o t t l e d w a t e r a n d
buckle it upside down on the smart
seat of the dispenser.
(2)Turn the pump switch to the "O" .
Lower Mounting
Load Powder
Lift the barrel upward and then gently pull it out according to the
arrow direction which is shown in the figure.
Powders options
(1) Please cover the barrel lid properly after loading the powder.
(2) When loading powders, please tilt the barrel back slightly to
prevent the powder from leaking out of the barrel.
(3) After loading the powder, please do not press the powder in case
the powder becoming lumpy.
(4) Please make sure the rotating shaft of barrel is properly fit with
the beater shaft.
(5) Please make sure the pins on the bottom of barrel should be
located in the slot of the stand.
Caution
Loading Material
Unsuitable Powders
Block or granular powders
Viscous or granular powders
Suitable Powders
Coffee powder
Ginseng tea
milk powder
Mixed powder
coffee
Other powders
(1) Place a bottle filled with water beside
the dispenser and remove the lid.
(2) Insert one end of the inlet pipe into the
bottle and the other end screw the nut
onto the dispenser.
(3) Cover the smart seat with the smart
seat cover.
