Healy Wellness, Instructions For Use Manual, Page: 11 / 520

EN | 11 Healy GmbH | Schloss Kränzlin | Darritzer Str. 6 | 16818 Kränzlin – Germany
WARNINGS :
• A reduced contact between the skin and the electrode may cause
the electric current to concentrate in one point and cause burning.
• Interrupt the application if there is discomfort or a burning sen-
sation.
• After the session, turn off the device, disconnect the cable from the
electrode and gently remove the electrode from the skin by lifting
it up by one corner.
• Rapid removal of the electrode could cause skin traumas.
• Do not remove by pulling the connection part of the cable.
• After use, reposition the electrodes in the plastic liner and put them
back in the pouch.
• Electrodes may be reused: Reuse only for the same person.
• Verify the adhesion of the electrode before use. When electrodes
lose adhesion, gently rub one or two drops of water onto the gel
surface. This may extend the lifetime. If there is no improvement,
replace with new electrode.
• Keep the packet closed in order to prevent the unused electrodes
from becoming dehydrated.
• Do not reposition the electrode during use.
4. Operating the Healy
You should become familiar with these frequently used operations:
•
switch On-Off (please refer to chapter 3.1.5 and 4.4)
• select application (please re-
fer to chapter 4.1)
• start application (please refer
to chapter 4.1)
• connect the electrodes
(please refer to chapter 3.1.6)
4.1 Starting the application
using the smartphone
After the installation of the App,
pairing and connection of the
electrodes, the Healy is ready
for operation. In the overview
screen you can select which
program category you want to
use (see figure 4.1.1 ).
After selecting a program cate-
gory the program page with the
icons of the different programs
is loaded (see figure 4.1.2 ).
After you select a program from
the program page screen the
information for placing the elec-
trodes is displayed (see figure 4.1.3 ).
After selecting “Start” on the information page the application is start-
ed and the application page is loaded (see figure 4.1.4 ). In the appli-
Figure 4.1.1: Overview interface