12
V. Installation Instructions
HA-CMSC-G2-3-WS/WD
5.6 Install Flex Hose
The Flex Hose is constructed of interlocking bands that enable its length and
shape to be adjusted. Note that, the Flex Hose will unravel if it is lengthened or
bent past its tolerance point. The diameter of the Flex Hose can be also
adjusted by rotating sections of the hose counterclockwise.
Note, if the LED Lighting option was selected, proceed to complete the
instructions in Section 5.7 prior to doing the following.
5.6.1 Remove the two (2) Thumb Screws that are installed on the Inlet Tube,
as shown in Fig. 6.
Fig. (6)
–Inlet Tube with Thumb Screws
5.6.2 Note that, there are two (2) Screw Holes at the base of the Flex Hose
that match the two (2) Screw Holes in the Inlet Tube.
5.6.3 Slide the end of the Flex Hose over the Inlet Tube and align the two (2)
Screw Holes in the Flex hose with the two (2) Screw Holes in the Inlet
Tube, as shown in Fig. 7.
5.6.4 Reinstall the two (2) Thumb Screws, such that they pass through the
Screw Holes, to secure the Flex Hose to the Inlet Tube.
5.6.5 Position the Hose Clamp directly beneath the Thumb Screws on the
Flex Hose and screw the hex nut to tighten the Hose Clamp.
Thumb
Screw
Thumb
Screw
