Page 18
12/12
Suspending the Unit using adjustable hanging straps
Use 4 screws and 4 washers (field provided) to attach the hanging straps to the floor joists. The washer must be wider than
the eyelet of the grommet on the hanging strap. By design, the adjustable hanging straps reduce the possibility of noise,
resonance, and harmonics.
Buckles
Joist
Hanging Strap Grommets
Hand Loops
Screws and Washers
(field provided)
Step 1. Insert the screws and washers (field provided) through
the Hanging Strap Grommets and fasten to the joists.
Step 2. Unscrew the 4 machine screws located on the upper
side of the unit. Attach the S" hooks and reinsert the ma-
chine screws.
Note: This illustration of
the unit may vary from
the unit you are installing.
Step 3. Hook the bottom grommets of the straps through the S"
hooks. Pull down vertically on the hand loops while lifting
up the bottom of the cabinet. Repeat at opposite end of
the unit,
Pull down
hand loops...
while
lifting
up on unit
Buckles
Note: Do not pull
the hand loops in a
horizontal direction
(laterally with the
unit) during installa-
tion or during ad-
justment of the
straps.
Step 4. Level the unit from left to right and front to back.
− Adjust the unit down by lifting up on the buckles.
− Adjust the unit up by pulling down vertically on the hand
loops while lifting up the bottom of the cabinet.
Step 5. Fold the hand loops and excess strap and secure with
a nylon tie (field provided).
Straps
S" hooks
Figure 14. Suspending unit using provided Hanging Straps (HRV unit shown)
