Healthstream T790, Service Manual

Page: 19 / 61

T790 Treadmill
How To… Replace The Running Belt and Deck - Continued
Tools Required : Allen key set, Phillips screwdriver, tape measure, rubber hammer, and open end wrench set. (All
fasteners are metric. Make sure that you have metric tools.)
Section 3 3
S
e
c
ti
o
n
I
II
REMOVAL AND INSTALLATION –
Continued
10. Remove the front roller long screw,
short screw, and curve washer from
the front roller mounting brackets, and
then lift the front roller out of the
running belt. If necessary, remove the
motor drive belt.
12. Remove the deck screws (10) and
washers (10), then lift out the deck.
13. Remove the running belt and discard.
14. Install a new running belt and a new
deck in reverse order. Re-tension the
motor drive belt to 85~95 lbs. Do not
over tighten belt.
NOTE: when adjusting motor belt
tension, the four mounting screws
should be loosen, and then adjust
motor belt tensioning screws (2) to
make sure the motor drive belt to
85~95lbs.
15. Proceed to the following page for
proper belt stretching and belt tracking
adjustment.
16. Install the deck and running belt in the
reverse order