head rush technologies TRUBLUE iQ, Operator'S Manual

Page: 37 / 48

10.7.2 WEBBING LINE REPLACEMENT PROCEDURE
To replace the webbing line:
1. Remove the Auto Belay from service.
2. Remove the Nozzle assembly – Refer “To Remove Nozzle Assembly” above.
3. While holding Auto Belay securely, pull out the webbing line until the end
of the short webbing loop and the joining shackle are exposed.
4. Locate the loop in the short webbing loop, approx. 150 mm (6 in) past the
shackle. Twist webbing 90 degress and place the Nozzle Assembly pin
through the loop in the short webbing loop to prevent it retracting back
inside the casing.
SHORT WEBBING LOOP
NOZZLE
ASSEMBLY PIN
SHACKLE AND SHACKLE PIN
WEBBING LINE
Webbing joining link parts
5. Unscrew the shackle pin.
6. Remove webbing and shackle pin from the short webbing loop.
7. Ensure the loop part of the shackle is fitted to the short webbing loop.
THREAD LOCKING COMPOUND
Ensure the factory applied thread locking compound is present on the
shackle pin threads. Do not reuse the Shackle Pin.
WARNING
The TRUBLUE iQ can only use TRUBLUE iQ webbing. Do not use
original TRUBLUE webbing, or any webbing from any other manufacture.
Incompatible webbing may result in severe injury or death if used. The
TRUBLUE iQ webbing has a white yarn down the center and is sold by
authorized Head Rush Technologies locations.
37
www.headrushtech.com | +1-720-565-6885