HDT NTT 240, Installation And User Manual

Page: 10 / 130

10
Installation and user guide
Rev: 4.0
NTT 240/460
Introduction
2.03 Drive sizes and option configuration
The power available is covered by following models:
MODEL
Output Current Dimension Power Voltage
Rated Maximum
Mechanical
Size
V
AC
/ V
DC
nominali Name Size A
rms
NTT 240
1.5/3
1.5 3
T0
230V
AC
/ 300V
DC
3/6 3 6
6/12
6 12 T1
10/20 10 20 T2
NTT 460
1.5/3
1.5 3 T0
400V
AC
/ 540V
DC
3/6 3 6 T1
6/12
6 12 T2
10/20
10 20
T3
20/40
20 40
35/70
35 70
T4 45/90 45 90
45/150
45 150
75/150 75 150 T5
100/200*
100 200 *
150/300* 150 300 *
200/400*
200 400 *
Available configurations differ for fieldbus option and for secondary feedback desired and are shown below:
Label CONFIGURATION description
ST
“STANDARD” (no installed option)
I/O operation mode: analog, frequency and I/O commands.
Feedback1 from incremental encoder with/without HALL and SSI absolute encoder.
ST R
“STANDARD”
+
“R” Feedback option installed
I/O operation mode: analog, frequency and I/O commands.
Feedback1 from incremental encoder with/without HALL and SSI absolute encoder.
Feedback2 from resolver.
CM
“CM” Fieldbus option installed
Canopen CiA402 or Modbus RTU operation mode.
I/O operation mode: analog, frequency and I/O commands.
Feedback1 from incremental encoder with/without HALL and SSI absolute encoder.
CM R
“CM” Fieldbus “R” Feedback option installed
Canopen CiA402 or Modbus RTU operation mode.
I/O operation mode: analog, frequency and I/O commands.
Feedback1 from incremental encoder with/without HALL and SSI absolute encoder.
Feedback2 from resolver.
*This model is under development. For information please contact our technical department.