FS22DI
OPERATION
16
Information
The definition of the network properties shall comprise three digits to define each number
– e.g., 010.000.000.150:255.000.000.000:000.000.000.000 –.
Resetting IP to Default
If for any chance there is the need to physically change the IP address of the interrogator,
there is a reset procedure that consists on pressing the ON/OFF button for more than
10 seconds.
When the button is being pressed for 10 seconds the POWER LED blinks 3 times and
goes OFF. At this moment the ON/OFF button can be released and the reset of IP address
will happen.
Resetting IP to Default
If by any chance there is the need to physically change the IP address of the interrogator,
press the "ON/OFF" button for more than 10 seconds to reset the interrogator.
When the button is being pressed for 10 seconds the POWER LED blinks 3 times and
goes OFF. The "ON/OFF" button can then be released and the IP Address will be reset.
POWER LED
blinking at 1 Hz
POWER LED ON
POWER LED blinks
3 times and goes OFF
Fig. 3.9
Power led while pressing Switching Off for more than 10 s
This procedure resets the interrogator changing its IP address to the default and its mea
suring settings to the last ones stored.
Information
The interrogator default network properties are "10.0.0.150:255.0.0.0:0.0.0.0".
3.6.3
Synchronization
In order to achieve synchronous measurements between different devices the NTP (
Net
work Time Protocol
) synchronization via Ethernet must be used
.
