Battery Power
When the Wireless Terminal is in the charging cradle, the unit uses wall power while also charging
the battery. It will always be “awake” and connected to the OmniLogic (even if the display is off),
as long as it's sitting in the charger. The Wireless Terminal can not be overcharged and is safe to
leave it in the charging cradle when not in use. The Wireless Terminal should be returned to the
charging cradle after each day's use.
When the Wireless Terminal is not in the charging cradle, it uses battery power and will take steps to
extend battery life. While "awake" it will be connected to the OmniLogic. After a user defined time
interval, the Wireless Terminal will go to "sleep", turning off its display and disconnecting from the
OmniLogic. To awaken it from sleep, simply touch the display. Even though the display will turn on
immediately, the Wireless Terminal will take about 5-8 seconds to reconnect to the OmniLogic. Wait
until the Remote Connection icon turns white before sending commands to the OmniLogic.
To set the sleep time interval, refer to the diagram below. Select 30 seconds, 1 minute or 2 minutes.
POOL
vsp pump
mode
idle
charger
30 seconds
battery
1 minute
2 minutes
DISPLAY
setting
2 / 2
12h
ºF
vs%
100%
SYSTEM
configuration
1 / 2
display
system info
network
omnilogic server
date/time
language
datalog
shell command
favorites
config
heating
themes
º
F
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
6
