SYSTEM
configuration
1 / 2
wireless
date/time
language
datalog
system info
display
network
omnilogic
WIRELESS
manage
home_guest
ssid
security
linksys
home_poolpad [WPA2-PSK-CCMP]
[WPA2-PSK-CCMP]
[WPA2-PSK-CCMP] 100
100
0
01
02
03
signal
ON/OFF
WIRELESS
add wireless network
manage wireless networks
The Wireless Terminal displays the "Searching" screen.
The OmniLogic system is not discovering the Wireless Terminal. To troubleshoot this issue,
perform the following steps:
1. Make sure you're within range of the home's wireless router. Refer to the Remote
Connection icon to determine if the Wireless Terminal is connected to the home network. If
not (red icon), resolve the connection issue according to the instructions on page 3. If the
icon is yellow, proceed with the next step.
2. Make sure the OmniLogic is connected to your home network by sending commands through
the user's online account via a web browser or the mobile app.
3. Follow the screens below from the Wireless Terminal to check that you are connected to the
proper network and that there is a good signal.
4. Verify that you have an IP address by following the screens below. If no IP address is present,
toggle the on/off switch in the corner to “Off” and then back to “On”. An IP address and infor-
mation should be filled in for all fields as seen in the screen below.
CONFIGURATION
selection
Local IP
Netmask
Gateway
DNS1
DNS2
protocol properties
172.16.170.70
255.255.255.0
172.16.170.1
192.168.100.47
192.168.100.251
static
dynamic
ON
SYSTEM
configuration
1 / 2
system info
display
network
omnilogic
date/time
language
datalog
shell command
Verify that there is a pointer next to the same network name used by the OmniLogic. If the
pointer is not next to your network name, try reconnecting (page 3).
Searching for OmniLogic. Please
Wait.
en
9
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
