5. If there is an IP address but still no configuration after 3 minutes, manually enter the IP address.
First confirm that the OmniLogic can be controlled by a web or mobile application, then follow
the screens below:
If your router is set up to dynamically assign IP addresses, it may randomly change the IP ad-
dress that is assigned to the OmniLogic. If this happens, the Wireless Terminal will not be able
to connect to the OmniLogic until the old IP address is replaced with the new.
My Wireless Terminal works in the charger but shuts off when removed.
This may be a battery issue. Contact Hayward Technical Support.
The Wireless Terminal is not behaving normally. Can it be reset?
To reset the Wireless Terminal, put it in Storage Mode (page 8) and then back into the charging cradle.
This is essentially the same as removing the batteries and then reinstalling, essentially "rebooting"
the Wireless Terminal.
The Wireless Terminal won't enter Storage Mode.
Be sure to line up the charging pins with the reset magnet and swipe from left to right across the
magnet. If the unit won't go into Storage Mode, contact Hayward Technical Support.
My battery doesn't hold a charge or no longer charges.
If the battery no longer charges, contact Hayward Technical Support.
From OmniLogic:
CONFIGURATION
selection
Local IP
Netmask
Gateway
DNS1
DNS2
protocol properties
172.16.170.70
255.255.255.0
172.16.170.1
192.168.100.47
192.168.100.251
static
dynamic
ON
SYSTEM
configuration
1 / 2
config wizard
system info
backup config
restore config
display
network
web server
date/time
From Wireless Terminal:
OMNILOGIC
omnilogic
enter properties
static
dynamic
ON
SYSTEM
configuration
1 / 2
system info
display
network
omnilogic
date/time
language
datalog
shell command
Note the IP address found in the dynamic tab
from the OmniLogic’s network configuration
screen.
Under static tab, touch “omnilogic” and manu-
ally enter the IP address found previously from
Local IP of the OmniLogic.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
10
