Page 17 of 20
HEATPRO HEAT PUMP
HP13023770 Rev: E
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN
Tel: 908.351.5400 www.haywardpool.com
Connecting to Remote Systems
HAYWARD heat pumps are compatible, in the heating mode only, with one or more of the remote systems in
the pool and spa industry today.
Thoroughly read
all installation instructions of the remote system before connecting this unit.
The figure below shows the remote systems connections to the HAYWARD heat pump.
Connection to Compatible Remote Systems:
•
Connect two wires (24 VAC) from the remote system. In the
TB201 Terminal Block of the Interface board, connect one wire
into terminal 1, and the other into terminal 2.
•
The thermostat on the heat pump must be in the “Standby”
mode for the remote system to control the unit.
Or
•
Connect three wires marked as
pool, spa
, and
common
from the
remote system to TB201 Terminal Block as follows:
Terminal 3 = Pool
Terminal 4 = Common
Terminal 5 = Spa
•
The thermostat on the heat pump must be in the “Standby”
mode for the remote system to control the unit.
•
The thermostat on the heat pump will control the water temperature.
Initial Start-Up
After completing the electrical and piping connections to the pool heater, follow the procedures outlined below
to ensure that the pool heater is functioning properly.
Before proceeding,
MAKE CERTAIN
there are no air or water leaks in any plumbing connections or piping
and water flow is within the proper flow rate ranges. The proper flow rate ranges for ALL Hayward HeatPro
Heat Pumps are a minimum of 30 GPM and a maximum of 75 GPM.
Note: Damage caused by flow rates outside this range will void the warranty.
CAUTION
-
Keep all objects off the top of the heat pump. Blocking airflow could damage the unit
and will void the warranty.
Thermostat Interface Board in the unit
Control Box
